Short Form Specifications
Cabinet top surface shall be 22-gauge stainless steel. Insulated fold-
ing lid shall be stainless steel with high impact plastic liner and have
chrome plated, die cast handles. Opening shall have a throat liner
constructed of high impact plastic.
The exterior sides shall be 20-gauge stainless steel. The watertight
inner liner shall be 22-gauge stainless steel. The unit shall be insu-
lated with foamed-in-place high density polyurethane.
Refrigeration system will be controlled by an electronic control with
built in defrost timer. System will also include a blower coil and a
1.00" (2.5cm) I.P.S drain. Unit designed to maintain a temperature
setting from -5ºF to 40ºF (-21ºC to 4ºC).
THE FOLLOWING APPLIES TO MODELS CPB-2 AND CPB-4 ONLY:
Stainless steel perforated dispenser tubes (2 on CPB-2 and 4 on CPB-
4) for plates shall be furnished with properly calibrated, non-fatiguing
stainless steel springs. Each dispenser tube shall have a maximum
capacity of approximately 50 plates.
NOTE: The maximum dish diameter that can be dispensed by these
models is 9.62" (24.4cm).
THE FOLLOWING APPLIES TO MODEL CMB-2 ONLY:
Self-leveling mechanism to be field adjustable by adding or removing
stainless steel extension springs on perimeter of vertical side chan-
nels. A 20.00" x 20.00" (50.8cm x 50.8cm) carrier tray shall be pro-
vided. The dispenser shall have a capacity of three to four 20" x 20"
racks (50.8cm x 50.8cm). Racks are not supplied by Delfield; must
hold 20-25 mugs.
Optional Accessories and Modifications
•
Lid-locking device (specify model number)
•
Special voltages (consult factory)
Built in chilled mug and plate dispensers
PROJECT
ITEM #
QUANTITY
DATE
APPROVAL
CMB/CPB
MODEL CMB-2
MODEL CPB-2
The Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.com
Delfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A.
