Display Cases 724, 7000, 9000 Series Service and Installation Manual
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
2
Display Cases 724, 7000, 9000 Series Service and Installation Manual
3
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
RECEIVING AND INSPECTING THE EQUIPMENT
Even though most equipment is shipped crated, care should be
taken during unloading so the equipment is not damaged while
being moved into the building.
Carefully check for any visible signs of damage to the cartons or
containers. If evidence of damage exists, the package should be
opened immediately and a joint inventory and examination of the
contents should be made by you and the driver. Sign delivery
receipt as damaged. Example— if (2) pieces of (5) are dam-
aged, you must indicate the number of units damaged.
Concealed damage
If a concealed loss or damage is discovered after you have
given the carrier a clear delivery receipt,
notify the carrier
in writing immediately or within 10 days from the delivery
date
. If you phone the carrier, you must follow up the call
in writing to protect your rights. You can only improve your
position as a claimant by promptly reporting such loss or
damage. You should also
retain all cartons or containers,
including packing material
, until an inspection has been
made or waived.
Filing a claim
Notation of loss or damage does not constitute the filing of
a claim. You should file your claim
in writing
with the carrier
immediately!
Carriers will furnish the necessary form upon request. You
should also request an inspection. If a claim is filed by phone,
always follow up immediately in writing.
Location
Delfield 7000 and 9000 Series and Model 724 display cases
should be installed on a level surface away from any source
of intense heat such as ovens or ranges. Do not install 9000
Series units closer than 6" (15.2 cm) from the ceiling or
counter. This will allow air flow to the machine compartment.
The 724 should be installed on legs as provided (4" [10.2 cm]
from the counter).
When using a Model 724 display case, never obstruct the
flow of air to the top of the cabinet. Do not place or store any
items on top surface of unit. Obstruction of air may cause
damage to the compressor.
On 7000 Series pass-through or see-through units, the cabi-
net can be installed with the machine compartment side flush
against a wall or obstruction as long as both the front and
the rear louvers are unobstructed. Do not install 7000 Series
mirrored units closer than 6" (15.2 cm) from the wall.
If installing a 7000 Series display case into a counter-top, you
must seal the perimeter of the equipment with silicone seal-
ant (see diagram below).
INSTALLATION
For the most efficient refrigeration, be sure to provide good
air circulation inside and out. Take care not to block air flow
to the fans and allow space along the sides.
Do not pack the interior of the display case so full that air
cannot circulate.
Leveling
A level cabinet looks better and will perform better because
the doors will line up with the door frames properly, and the
cabinet will not be subject to unnecessary strain.
Electrical connection
Refer to the amperage data on page 2 or the
serial tag data and your local code or the
National Electrical Code to be sure the unit
is connected to the proper power source. A
protected circuit of the correct voltage and
amperage must be run for connection of the
line cord or permanent connection to the
unit.
The power should be disconnected when-
ever performing maintenance or repair
functions. Failure to observe this warning
may result in electrical shock and personal
injury!
