- 7 -
English
WATER SUPPLY CONNEC-
TION
Connect the water hose to
the water supply (fig. 4A) and
to the inlet on the cleaner
(fig. 4B).
Check that the pressure and
quantity of the water supplied
by the mains are sufficient for
the cleaner to work properly: 2
to 8 BAR (29 to 116 PSI).
Maximum temperature of fee
-
ding water 50°C (122°f).
Connect the high pressure
hose to the cleaner (fig. 4C)
and to the lance (fig. 5).
IMPORTANT.
The cleaner must operate
with clean water. Dirty or
sandy water, corrosive che-
micals and solvents can
cause severe damage to
the cleaner.
failure to respect the above
absolves the manufacturer of
all liability and represents ne-
gligent use of the product.
ELECTRICAL CONNECTION
Connection of the cleaner to the mains must be carried out by
skilled technicians able to ensure that all regulations in force
are complied with
use in respect of current standards and
legislation.
Ensure that the mains voltage available is the same as the vol-
tage at which the cleaner is supposed to work; this is indicated
on the identification plate.
Unwind the cable completely from the cable tidy to avoid
overheating.
The electric cable must be protected from accidental cru-
shing.
Do not use the machine if the supply cable is damaged.
The use of any electric appliance requires the respect of
some basic rules:
• Do not touch the appliance with wet or damp hands or feet.
• Do not use the appliance bare-footed or with unsuitable
clothing.
• Do not pull the supply cable or the appliance itself in order
to disconnect the plug from the electric supply. (for water
cleaners rated at less than 3 kW fitted with plug).
As for the protection against electric shock, the H.P.cleaner
belongs to
CLASS I.
Failure to observe the above warning frees the manu-
facturer from all responsibility and constitutes negligent
use of the product.
fIG. 5
!
!
!
!
!
A
B
C
fIG. 4
