Owner's Manual
Page 6
INSTALLATION
1. LOCATION
Avoid operating units in small areas or near exhaust fans. Adequate oxygen is needed for combustion
or dangerous carbon monoxide will result. Stationary units should be installed in accordance with local
plumbing and heating codes.
2. FUEL SUPPLY
Oil Fired Units: Fill fuel tank with clean kerosene, No. 1 home heating fuel, or diesel fuel (without
anti-gel additives.)
3. VENTING THE UNITS -
If the unit is to be used in an enclosed area it must be vented out.
The Draft Regulator (on oil-fired units) and chimney must be
same size as the stack on the cleaner unit. Poor draft will cause
the unit to soot-up and not operate efficiently. When installing
the machine so the stack will be as straight as possible,
protruding through the roof at a sufficient height to eliminate
down-draft and to comply with local codes.
Always disconnect the battery when servicing your cleaner.
Summary of Contents for C984040V
