3000-4, 2000-5 NG/LP
Page 9
Stacking the Unit:
If the cleaner is used in an enclosed area be sure there is plenty of ventilation.. Be sure the chimney is the
same size as the stack on the cleaner. Poor draft will cause the unit to soot and not operate efficiently.
When placing the unit for installation, keep in mind that the unit should be positioned in such a manner that
the stack will be as straight as possible and protrude through the roof of the building at a proper location and
at sufficient height to eliminate downdraft.
A gas fired unit should have a draft divertor and proper rain protection on the vent pipe.
DANGER:
All gas burner equipped cleaners should be installed and serviced in accordance with the
requirements of your local gas company and all applicable state laws or local ordinances.
Water Supply:
1. Connect the machine to the water supply with 3/4" water hose and 3/4" connections.
2. Insure that the water supply is capable of supplying sufficient water flow volume.
CAUTION:
Insufficient water flow can cause pump damage and failure.
Gas Supply:
1. Insure that the gas cock knob is in the "Off" position.
2. Installation of gas service to this machine is to be made with 1" plumbing or larger. Refer to chart on
page 4.
Electrical:
CAUTION:
This machine must be electrically grounded.
1. Connect only to grounded outlets with 30 ampere, 230 volt a/c (alternating current), 60 Hz,
1
phase
circuits protected by fuses or circuit breakers and GFCI protection.
INSTALLATION CHECKOUT:
Before Starting:
1. Connect discharge hose and gun. Remove pressure nozzle.
2. Connect the water supply hose to the water inlet. Turn the water on and allow the water float tank to fill.
When the tank has filled and the flow through the float valve has stopped, check to insure that there is at
least 1" between the water level and the float valve opening.
3. Before connecting the power supply be sure that the control switch is in the "Off" position.
