OPERATION
• Make sure switch
a
(
Fig. A
) on the hair dryer cradle is switched to the ‘ON’ position.
• Select the drying temperature using the switch at the back of the hair dryer handle
b
.
• The hair dryer will operate when button
c
on the front of the hair dryer is pressed.
Release button
c
to stop the hair dryer.
• The cradle for this model has a 230V and 110V socket which should only be used
for electrical shavers or electrical epilators.
• Switch to the ‘OFF’ position
a
and unplug the mains supply after every use.
• Power supply: 1200W, 220-240V~ / 50-60Hz.
•
Do not use the appliance near bathtubs, showers, wash basins
or any other water source.
INSTALLATION - CONNECTING THE ELECTRICITY
• Electrical supply 220-240V / 50-60Hz Class II.
•
The installation must conform to current legislation in your country.
• Install a 30mA differential circuit breaker to provide additional protection.
• Drill 2 holes Ø6 in the wall as shown in
Fig. B
.
• Insert 2 rawl plugs
g
(
Fig. A
) into the holes in the wall.
• Fasten bracket
d
(
Fig. A
) to the upper hole. Mount the hair dryer cradle on the bracket
then tighten screw
e
(
Fig. A
) through the lower hole. Cover the hole with cap
f
(
Fig. A
).
• Connect the power supply and switch to the ‘ON’ position to use the hair dryer.
REMEMBER
•
Our products must be installed by professional installers
in accordance
with current regulations and recommendations in your country.
• In case of malfunction, immediately switch off the power supply and contact
the After Sales team.
• Do not cover and do not obstruct the air vents or outlet.
• Check that the air vents are clean and free from dust and/or hair.
• If the hair dryer overheats it will stop automatically and re-start after several minutes.
• Do not shake the hair dryer.
• Hold the hair dryer approximately 10cm from the hair to prevent any risk of burning.
• Do not install the hair dryer outdoors.
EN
