Dekema AUSTROMAT 624, Operating Instructions Manual, Page: 35 / 155

AUSTROMAT
®
624 / 644 4. Start-up
Operating Instructions (Version 01/2012) 35
Fig. 4-6 Login window
4. The Program Manager appears in the VNC window (see section 5.3).
Set up a permanent IP address for the firing furnace (see section 4.4.4).
4.4.4. Set up a permanent IP address for the firing furnace
You can now operate the firing furnace using the VNC program. Depending on the network
settings, a different IP address can be used each time the unit is started. So that you do not
have to repeatedly find and enter the IP address, the firing furnace should be assigned a fixed
IP address in the network.
1. Contact your network administrator, and have him assign an IP address and subnet mask
and gateway address for the firing furnace.
2. In the "Setup" menu, open the "Network" function (> Setup > Network).
Fig. 4-7 Assign permanent IP address
3. Under "Default IP address", enter the IP address that was assigned to the firing furnace by
the network administrator.
4. Under "Default Subnet mask", enter the subnet mask that was assigned to the firing
furnace by the network administrator.
5. Under "Gateway", enter the gateway address that was assigned to the firing furnace by the
network administrator.
6. Deactivate the DHCP function.
7. Click on [OK].
The firing furnace now has a fixed IP address and can be accessed using a browser or the VNC
program at this address.