9
© 1999 Directed Electronics, Inc
Refer to Figures 3 and 4 for details.
FIGURE 4
SYNCED GAIN OPERATION
(wiring diagram)
6. Remote sub level - connect a single
remote sub level control to each
amplifier using a telephone cable
splitter as shown in Figure 3.
7. The master amplifier’s gain control
(Figure 3) is used to set the overall
sub amp gain. The gain controls of
the slaved amplifiers are not func-
tional and the overall gain is set by
the master amps gain and then by
the remote sub level control.
8. Connect the outputs of each ampli-
fier to their separate subwoofer
load. In synced gain operation each
amplifier can drive a 1, 2, or
4 ohm load.
9. Remember that the amplifier paral-
lels any speaker load connected to
the two pairs of supplied terminals.
You may safely connect one 2 ohm
subwoofer or 2 ohm combined load
to each of the two pairs of termi-
nals or one 1 ohm subwoofer or 1
ohm combined subwoofer load to a
single pair of (+/-) terminals. Do
not connect combined loads of less
than 1 ohm to the amplifier.