24.03.2017
ASSEMBLY AND OPERATING MANUAL DEGERtracker D60H, D80, D100
Page 20
4.
Mount the top and bottom longitudinal beams to the cross-
bars with two bolts M16x70, two washers and one self-
locking nut M16 each.
On the longitudinal beams, the projection of the flange plate
must point downwards!
Tightening torque: 300 Nm
On the DEGERtracker D100,
fasten the two tie rods with
the eyelet to the outer bolt connections.
Insert the opposite end through the slot in the U-section and
fix loosely with washer and two nuts M12.
6.
Fasten the U-sections to the longitudinal beams with one
bolt M12x40, two washers and one self-locking nut M12
each.
Tightening torque: 84 Nm
7.
On the D100,
keep turning the nut M12 on to the thread
of the tie rod, until the tie rod, is slightly tensioned.
Do not tighten too much, since this may distort the frame!
The red marked nut is a lock nut.
Tie rod
only with DEGERtracker D100
