Page 5
Unpacking
Please ensure that packaging material is disposed
of in a responsible manner.
Plastic bags should be cut up to prevent children
playing with them and accidentally suffocating.
Remove all packing from the oven cavity and
position the accessories.
If the appliance is damaged in any way, do not
use it. Report the damage to your dealer, who will
take the necessary corrective action.
3. Setup
LPG Gas Only:
Do not install this
appliance in a room below ground
level unless it is open to ground level
on at least one side. Failure to install
appliances correctly is dangerous
and could lead to prosecution.
WARNING!
ELECTRICAL
CONNECTION MUST ONLY BE
DONE BY A QUALIFIED
ELECTRICIAN
Do not carry the product using the
oven door handle, this may damage
your oven door hinges!
You may lift the product with the door
open by holding the inside of the
oven and the back of the hob.
Connection to the power supply
This appliance should not be connected through
an earth leakage system. Refer to S.A.N.S.
10142.
This appliance has a ‘Y’ type supply cord
connection and must be installed by a licensed
electrician, who will ensure that the stove is
correctly connected and safely earthed.
The rated current is printed on the serial number
label attached to the stove upper back panel.
The appliance must be connected to the mains
through an All pole isolating switch which has a
minimum clearance between the contacts of 3
mm in All poles. A means for disconnection must
be provided in the fixed wiring.
Important Information for the user
This appliance may only be installed by a
registered SAQCC Gas installer
. All registered
installers are issued with a card carrying their
registration number. Ask to be shown the card
before allowing the installation work to commence
and make a note of the Installer registration
number. Upon completion of the installation, the
installer is required to explain the operational
details of the appliance together with the safety
instructions. You will be asked to sign acceptance
of the installation and be provided with a
completion certificate. You should only sign for
acceptance of the installation when the installation
is completed to your satisfaction.
Important Information for the installer
This appliance may only be installed by a gas
installer registered with the South African
qualification and certification committee (SAQCC).
The appliance must be installed in accordance
with the requirements of SANS 10087-1for use
with LPG, SANS 827 for use with NG and any fire
department regulations and/or local bylaws
applicable to the area. If in doubt, check with the
relevant authority before undertaking the
installation. Upon completion of the installation
you are required to fully explain and demonstrate
to the user the operational details and safety
practices applicable to the appliance and the
installation.
