Page 14
Maintenance and cleaning
Unplug the dryer from the mains
before attempting any cleaning or
maintenance work.
Cleaning the lint filter
•
The lint filter collects lint and loose fibres
during drying and must be cleaned before
or after each drying cycle.
•
To clean the filter, open the door and
remove the filter by pulling it up and out.
•
Open the filter as shown.
•
Clean the accumulated lint by hand or
using a soft cloth.
•
Rinse under running water if necessary to
open the pores in the mesh.
•
Dry and close the filter
•
Reinsert it in it’s housing.
Cleaning the door and door gasket
Clean the entire inner surface of the door
and the door gasket with a moist cloth.
Cleaning the moisture sensors
•
Humidity sensors are on the inside of the
dryer and detect when the laundry is dry.
•
The sensors should be cleaned every
three months.
•
Wait until the dryer has cooled down and
wipe the metal surfaces of the sensors
with a soft cloth dipped in vinegar, then
wipe dry.
Draining the water tank
•
Dampness from the laundry is removed
during drying and condenses in the water
tank
•
Drain the tank after each drying cycle.
•
Should you forget to drain the tank, a
warning symbol in the display will display
when the tank is full.
•
Open the drawer and carefully remove
the tank.
10