Page 9
3 Installation
The manufacturer accepts no liability for
installation. Any action that the manufacturer
has to take as a result of an erroneous
installation will not be covered by the
warranty. Installation, including gas and
electrical connections, must be carried out
by qualified personnel. An installation by an
unqualified person may constitute a hazard.
The manufacturer shall not be held
responsible for injury to persons or
damages arising from procedures carried out
by unauthorized persons or due to non
compliance with these provisions.
Installation, preparation of location
and electrical and gas installation
for the appliance falls under the
customer’s responsibility.
DANGER
The appliance must be
installed in accordance with all
local gas and/or electrical
regulations.
DANGER
Prior to installation,
visually check if the appliance has
any defects on it. If so, do not
have it installed. Damaged
appliances are a safety risk.
Before installation
This appliance is designed for installation in
a domestic worktop. A safety distance must
be left between the appliance and the
kitchen walls and furniture. See figure
overleaf (values in mm).
x
This appliance can also be used in a free
standing position. Allow a minimum
distance of 750 mm above the hob
surface.
x
(*) If a cooker hood is to be installed
above the appliance, refer to the cooker
hood manufacturers instructions regarding
installation height (min 650 mm)
x
Remove packaging materials and
transport locks.
x
Surfaces, synthetic laminates and
adhesives used must be heat resistant
(100 °C minimum).
x
The worktop must be aligned and fixed
horizontally.
x
Cut the aperture for the hob in the
worktop as per installation dimensions.
This appliance uses LPG (Liquid petroleum
or bottle gas) This appliance requires an
operating pressure of 2.8-3.0 kPa. A suitable
LPG regulator that complies with the
requirements of SANS 1237 must be used.
The manufacturer and the seller do not
accept responsibility for any damage due to
incorrect installation or gas connection.
x
Gas bottles should be located outdoors in
a suitable ventilated lock-up.
x
The connecting hose should not exceed
200 cm in length.
x
An appliance without a flame failure
device may only be used with a free
standing cylinder placed adjacent to but
not closer than 300 mm to the appliance.
Safety installation
x
A removable horizontal board must be
fitted below the hob and 75mm away from
the worktop bottom face.
x
Space between this board and the
appliance must be empty and no objects
may be stored or kept there.
x
This board will effectively shield the user
from the base of the hob which gets hot
during use. The board needs to be
removable for service purposes as the
hob, once installed, can only be loosened
from below.
x
If the appliance is installed with a side
adjacent to a vertical kitchen cabinet, the
distance between the edge of the
appliance and that of the cabinet side
must be a least 150mm. The distance
between the back wall and the rear edge
of the hob must be at least 55mm.
1
Minimum of 50 mm
