Page 10
Safety installation
x
A removable horizontal board must be
fitted below the hob and 75mm away from
the worktop bottom face.
x
Space between this board and the
appliance must be empty and no objects
may be stored or kept there.
x
This board will effectively shield the user
from the base of the hob which gets hot
during use. The board needs to be
removable for service purposes as the
hob, once installed, can only be loosened
from below.
x
If the appliance is installed with a side
adjacent to a vertical kitchen cabinet, the
distance between the edge of the
appliance and that of the cabinet side
must be a least 150mm. The distance
between the back wall and the rear edge
of the hob must be at least 55mm.
Earth leakage
This hob should not be connected through
an earth leakage system.
Refer to S.A.N.S. 10142
Aperture size
Fitting the hob
x
The hob is supplied with securing clips.
x
These fit into dedicated slots around the
hob base. (see picture A).
x
Insert the clips. (as shown in picture B).
x
Lift the clips up until they click into place.
(as shown in picture C).
x
To avoid liquid spills penetrating between
the hob and the worktop, apply the
supplied self- adhesive seal to the
perimeter of the aperture. Do not use a
silicone sealer.
x
Invert the hob on the worktop adjacent to
the aperture before making the electrical
connection. This will ensure sufficient
cable length for subsequent servicing.
x
Position the hob into the aperture so that
the securing clips are compressed
between the hob base and the worktop.
(see diagrams below).
A
B
C
1
Minimum of 50 mm
