owner’s manual
Studio
11
www.definitivetech.com
On-Screen Display (OSD) Set-Up
Menu Functions
(only available when using HDMI hook-up method)
With your TV ON, press the MENU button on the remote. The OSD screen
appears on your TV. To exit the menu at any time, just press the MENU
button. The functions:
SOLOCINEMA STUDIO MENU
WI-FI
NIGHT MODE
IR LEARN
SUB CONNECTION
SSA IMMERSION
HDMI AUDIO
SYSTEM
1. Wi-fi:
See Wi-Fi setup on page 6.
2. Night Mode:
This is a useful feature to use late at night if other family members are
asleep. When Night Mode (Dynamic Range Compression) is turned
onpeaks in the audio signal are compressed. This makes it easier to
hear at low volume levels. At the same time more intense sounds (like
explosions) are reduced.
NIGHT MODE
ON
OFF
3. IR Learn:
IR Learn is used to program SoloCinema Studio to respond
to other remote controls like your cable box or TV’s remote IR
commands.
IMPORTANT NOTE:
In some rare instances, a television may create
enough IR pollution to block the sound bar’s learning capability.
Should you experience this with your television, turn your TV on but leave
the source off. This should eliminate any IR pollution. The TV screen
will be black, but you will be able to work with IR LEARN OSD to
program commands.
Your bar can learn to respond to the following IR commands from other
remote controls:
1. POWER
2. VOLUME Up and Down
3. MUTE
4. INPUT SOURCE commands (up to six inputs).
The OSD is used to teach the remote commands to SoloCinema Studio
(see example below):
NOTE:
IR learn function should be completed within 3’ of the sound
bar. The accuracy decreases as you get further away.
To learn your TV remote’s Volume UP command:
With the SoloCinema Studio powered on,
1. Press the SoloCinema Studio remote control MENU button to open
the OSD
2. Scroll down to the third menu box: IR Learn
3. Click right arrow on the Studio remote directional control,
and VOLUME UP Illuminates
4. Press the Studio remote ENTER key.
NOTE:
You will see the words “PRESS & HOLD KEY”
displayed on the OSD.
5. Pick up the remote you wish to have the SoloCinema
Studio learn—for example, the TV remote. Press and hold
the Volume Up key
6. The words “PRESS & HOLD KEY” now change to say
“RELEASE.” Release the TV remote’s volume up key and
the OSD again prompts you to “PRESS & HOLD KEY.”
7. The OSD will prompt you to PRESS & HOLD KEY three
times. The word “DONE” then appears on the lower right
hand corner of the OSD.
8. The OSD automatically navigates to STORE once the 3
press-and-release prompts have been completed.
9. Press the ENTER key while STORE is illuminated. The menu
now reverts back to highlighting the IR LEARN function.
IR LEARN
Power
Store
Volume Up
Cancel
Volume Down
Clear All
Mute
HDMI 1
HDMI 2
HDMI 3
AUX 4
OPT 5
BT 6
