2
Table of Contents
Table of Contents ......................................2
Safety Information ....................................2
Precautions ............................................2
Warranty ...................................................2
2-Year Warranty .....................................2
Specifications ...........................................3
Pre-Installation .........................................3
Planning Installation ..............................3
Tools Required .......................................3
Hardware Included .................................4
Package Contents ..................................5
Mounting Locations ...............................5
Installation ................................................6
Operation...................................................7
Care and Cleaning ..................................10
Troubleshooting ......................................10
Safety Information
PRECAUTIONS
□
Please read and understand this entire manual
before attempting to assemble, install, or operate
this light fixture.
□
This light fixture requires 120-volts AC.
□
Some codes require installation by a qualified
electrician.
□
This light fixture must be properly grounded.
□
This light fixture is intended for use with the
enclosed gasket and with a junction box marked for
use in wet locations.
□
This light fixture should be installed outdoors to a
wall or eave.
□
The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground. If the light fixture
is mounted higher than recommended, aiming the
sensor down will reduce the coverage area.
□
Do not leave the “ON-TIME” switch in the “TEST”
position. The frequent ON/OFF cycling of the light
fixture will reduce the life of the bulb.
WARNING:
Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
WARNING:
Risk of fire. Do not aim the bulbs at a
combustible surface within 3 ft. (1 m).
WARNING:
Risk of fire. Keep the bulbs at least 2 in.
(51 mm) from combustible materials.
CAUTION:
Keep the motion sensor at least 1 in. (25 mm)
away from the bulbs.
CAUTION:
Keep the bulb holders 30° below horizontal to
avoid water damage and electrical shock.
CAUTION:
To avoid water damage and the risk of
electrical shock, the motion sensor controls must be facing
the ground when the installation is complete.
CAUTION:
Burn hazard. Allow the light fixture and the
bulb to cool before touching.
CAUTION:
Do not cut any wires with factory installed
wire connectors or remove the wire connectors.
NOTICE:
Do not connect this light fixture to a dimmer switch or
timer.
Warranty
2-YEAR LIMITED WARRANTY
WHAT IS COVERED
This product is guaranteed to be free of factory defective parts and workmanship for a period of 2 years from date
of purchase. Purchase receipt is required for all warranty claims.
WHAT IS NOT COVERED
This guarantee does not include repair service, adjustment and calibration due to misuse, abuse or negligence, or
LEDs. Unauthorized service or modification of the product or of any furnished component will void this warranty in
its entirety. This warranty does not include reimbursement for inconvenience, installation, setup time, loss of use,
unauthorized service, or return shipping charges. This warranty is not extended to other equipment and components
that a customer uses in conjunction with this product.
Contact the Customer Service Team at 1-866-308-3976 or visit www.homedepot.com
