8
Operation (continued)
7
Adjusting the LUX control
NOTE:
The “LUX” control determines how dark the
surrounding light level needs to be before the motion
sensor (C) will turn on the light when motion is detected.
Ƒ
Turn the “LUX” dial toward the “ + ” position to
turn the light on when the surrounding light is
brighter (daytime).
Ƒ
Turn the “LUX” dial toward the “ – ” position to
turn the light on when the surrounding light is
darker (nighttime).
LUX
+
–
8
Completing motion sensor
setup
Ƒ
After all motion sensor (C) adjustments are
complete, rotate the motion sensor (C) so the
controls are facing the rear of the fixture (B)
and the two dots are in alignment.
Care and Cleaning
Ƒ
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
Ƒ
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
Ƒ
Do not spray the light fixture with a hose or power washer.
Troubleshooting
Problem
Possible Cause
Solution
The light will not come on.
Ƒ
Batteries are dead.
Ƒ
Replace the batteries.
Ƒ
Daylight turn-off (photocell) is in effect.
Ƒ
Recheck after dark or turn
the “LUX” dial toward the
“ + ” position.
Ƒ
The outside air temperature is close to
the same as a person’s body heat.
Ƒ
Increase the “SENS”
setting.
The light comes on during the
day.
Ƒ
The motion sensor may be installed in a
relatively dark location.
Ƒ
The light fixture is operating
normally under these
circumstances.
Ƒ
The “LUX” control is turned to the “ + ”
position.
Ƒ
Turn the “LUX” dial toward
the “ – ” position.
B
C
