CHANGING YOUR COMBINATION
It is advised that you change the combination regularly. To reset the key safe, enter your current combination to open the door and then follow
the steps in ‘Setting Your Combination’.
INSTALLATION
Before you start you will need the following items to install your key safe:
•
4 x thunderbolts - supplied
•
A power drill and extension lead
(or heavy duty battery operated power drill)
•
5mm masonry drill bit
•
Goggles or other suitable eye protection
Positioning your key safe
Your key safe should be carefully positioned so it is hidden from view. Typical locations might include: behind dustbins, plants,
plant pots, in dustbin bays, behind drain pipes, on the side or rear of the property or any other location that is out of sight.
Fixing your key safe
Select a flat area of wall in an area where you can drill into brick. Try not to drill into mortar as this can often crack and in any case
may allow the key safe to be prised off the wall. Ideally position your key safe across 2 or more bricks for maximum security.
Marking the wall
Using the installation template mark 4 x hole positions onto the wall with a marker or pencil.
Drilling the brick
The holes that secure the thunderbolts must be drilled to at least 50mm.
It is essential that the holes are the correct depth - if
not it will prove very difficult to fit the key safe properly.
Using the tape measure determine a distance of 50mm from the tip of
the drill bit and wrap some tape around the bit to act as a marker. This should help you to drill to the correct depth and avoid
drilling the holes unnecessarily deep. Drill the four holes to the correct depth using the power drill.
Inserting the thunderbolts & fitting your key safe
Position your key safe over the 4 holes and insert the thunderbolts through the holes and hand tighten.
Using your 8mm socket/ratchet/power drill carefully tighten the bolts. The bolts will “self tap” into the holes making the key safe
very secure. Do not over tighten as this may cause the key safe to distort in shape or the thunderbolts may bind into the metal of the
key safe.
Limited warranty
Solon Security warrants that this product will be free of defects in material and workmanship for one year from the date of purchase.
This warranty is limited to repair or replacement at Solon Security’s option. Damages caused by modification abuse or misuse, wear and tear,
improper installation, application, storage, or fault or negligence of a party other than Solon Security are not covered. Solon Security will not be
responsible for labour cost of removal or reinstallation of products. The repaired or replaced product is then warranted under the terms of this
limited warranty for the balance of the term of the warranty or for 90 days, whichever is longer. To obtain repair or replacement information
under the terms of this warranty, please contact your supplier.
Solon Security
Unit 40
Manor Industrial Estate
Flint, Flintshire
CH6 5UY
solonsecurity.co.uk
FS 565100 EMS 655345
Industry leaders in quality
IMPORTANT:
If the wall is not flat or if the thunderbolts are over tightened the key safe may distort. This will mean it may not close or open properly. This is
not a fault of the key safe and is not covered by warranty. In some cases the key safe may be rendered unusable. Care should be taken in
choosing a suitable even wall location and ensuring the fittings are not over tightened.
•
Marker / Pencil and Installation Template
•
Tape Measure
•
Roll of tape (electrical, masking or similar)
•
A ratchet, extension and 8mm socket or a 8mm
socket attachment for your power drill
