![DEFA DVS90 Installation Manual Download Page 66](http://html1.mh-extra.com/html/defa/dvs90/dvs90_installation-manual_2463336066.webp)
66
ENGLISH
Optional Components
1. Motion Sensor
2. Level Sensor
3. Remote Control
4. Backup Siren (Market dependent)
Base Components
1. Central Unit
2. Window Module
3. Siren (Market dependent)
4. Wire Harness
5. Hood Switch with switch guard enclosure
6. Window Stickers
7. User and Installation Manual
BEFORE YOU START
Check the contents. If anything is missing, contact your local dealer immediately. Note that the
package contents can differ, depending on market.
Carefully read the installation instructions before installing the alarm!
Disconnect the battery before starting to install to prevent short circuiting. Be careful with wires,
connectors and ground connection. Be aware of that moisture in connectors easily can cause
corrosion. To guarantee the alarm functions the alarm wiring should be checked yearly.
Where needed, a separate fuse must be installed, if no existing can be used. Neglecting this
can cause fire in the harness if a wire get squeezed or damaged. Document your installation
to simplify the service of the alarm system in the future.
The DEFA alarm system has an advanced PC configuration tool for adoption to different cars.
This installation manual only covers the standard installation for the system. Car specific instal-
lation guides comes with the configuration tool.
Stickers
Mount the enclosed (3 pcs.) stickers on the inside of the front door windows and the rear
window.
Placing the Alarm Unit
The alarm unit should be placed in a concealed location in the compartment of the car. (Free
from moisture!).
The wires must face down to prevent water running along the wires and in to the central unit.
WINDOW MODULE/GLASS BREAK SENSOR
Mount the window module on the inside of the windshield. The window module includes a
built-in glass break sensor.
1. Mount the window module sticker (enclosed in kit) on the inside of the windshield.
2. Mount the window module to the sticker with the adhesive tape
3. Connect the 4-pin connector to P3 on the alarm control unit.