background image

GB

29

How to use your DEFA AutoSecurity alarm

                                                    

Using DEFA remote: 

Your DEFA AutoSecurity Alarm Module is activated using the 

two buttons (A and B) on the remote control. The two buttons are easy to tell apart, as 

button A is noticeably higher.

Using the original remote for your car: 

The Alarm Module is operated with the lock/un-

lock button on the original remote control. When you have locked the car with the original 

remote, the Alarm Module will be set to ON.

«Press» means that you press the button for a maximum of 1 second. «Hold» means that 

you press the button for at least 2 seconds. Unlocking your car by using the key rather 

than the remote, will not set the Alarm Module to off.

Alarm ON (arm)

Using DEFA Remote: 

Press button A. The flashlights are activated once to confirm that the alarm is 

armed. The LED illuminates for 20 seconds and then starts to flash confirming that the alarm and the 

Glassbreakage/Microwave sensor is activated. 

Using the original remote for your car: 

Short press on the lock button. The flashlights are activated 

once confirming that the alarm is armed. The LED illuminates for 20 seconds and then starts to flash, to 

confirm that the alarm and the Glassbreakage/Microwave sensor is activated. 

Alarm ON (arm), closing of electric windows/ sun roof

Using DEFA Remote: 

Press button A. Keep it pressed until everything is closed. The Alarm Module is 

armed, the car is locked and the electric windows/sunroof are closing as long as the button is pressed. 

NOTE.

 The function is available on some car models only, please contact your nearest DEFA dealer to 

get more information.

Using the original remote for your car: 

The function is not possible.

   A   B

Summary of Contents for AutoSecurity










Reviews: