5
USING THE
MPULSE 3000
®
WITH A SALT WATER
CHLORINE GENERATOR OR AN OVER-
CHLORINATED SWIMMING POOL
CAUTION: THIS OPERATION SHOULD ONLY BE COMPLETED BY A
PROFESSIONAL
After completely removing power from the input power source using a suitable
disconnect or by unplugging the product, remove the protective plate by removing
the three screws holding it on. You will see the equivalent of the above diagram.
Note the switch labeled “A” and “B”.
Standard position is “A”. This will be used for swimming pools with standard
sanitization (chlorine, etc.).
For use with a “Salt Water Chlorine Generator”, and high conductivity pools
change the switch to the “B” position. Either position can be used to decalcify
pool. Unit will keep salt generators cleaner from scaling.
Replace the protective plate (screw torque: 25-in lbs) and continue with use of the
MPULSE 3000
®
.
