S. 10
Edition I / May 2012
opEratIng InStructIonS DEB1200D anD DLH1200D
C)
DMX mode
- Check to make sure that red mains switch is in off position „O“
- Connect light head (with lamp installed) to ballast with 7m connecting cable.
- Connectors are to be secured by the locking rings
- Connect external DMx controller to „DMx IN“ terminal on rear side of
DEB1200D
- Connect ballast with mains cable to a suitable outlet (as desribed in 3A)
- Switch ballast on (mains switch). Presence of power is indicated by light in the
switch. Ballast is now in ready state.
- Set the DMx adress by pushing the yellow push buttons „
↓
“ and „
↑
“
simulaniously, until the display stars blinking and release buttons.
- Now select channel with „
↓
“ or „
↑
“ buttons. The selected channel is for
dimming 50%-135%. The next following channel is automatically selected for
the ON/OFF feature.
Auto store of channel after 10 sec.
A yellow dot in display corner shows a correct DMx signal from external controller.
CAUTION:
DMX out terminal requires NO terminating resister.
DMX out signal is switched to a internal resistor if no output DMX cable is
connected.
