How to repair the Alliance machine without disassembling it
If you need to access the interior of the mixing shelves
to replace a belt or repair some components, it is
possible to access any of the shelves without
disassembling the en�re machine.
To do so:
1. Turn off the power to your Alliance mixing machine.
2. Remove the cans from the shelf you wish to access.
3. Remove the sha� guard from around the drive sha�.
4. Li� the shelf cover straight up on both the le� and
the right side.
5. Support the raised shelf with an object(s) to prevent
it from falling back into place.
You should now be able to access any of the internal
parts you need.
5
4
3
2
Gallon/4 Liter Drive Sha�
(33.35 cm, 13 1/8")
Quart/1 Liter Drive Sha�
(25.4 cm, 10")
Quart/1 Liter Motor Drive Sha�
(13.5 cm, 5-1/4")
Gallon/4 Liter Motor Drive Sha�
(21.45 cm, 8-1/2")
PN# 5996PLT
PN# 5995PLT
PN# P1243
PN# P1244
How to remove the drive sha�s
Once the expanding bolt has been removed (See “How to
remove the expanding bolt”) the drive sha�s can be removed.
You do not have to remove the sha�s to change a belt.
1. Turn off the power to your Alliance mixing machine.
2. Pull the sha� guards off of each sha�.
3. Li� the sha�s straight up and out beginning with the top sha�.
4. To remove a sha�, the one above it must be removed first.
5. It is good prac�ce to li� the sha�s that you do not need to
repair or replace and let them stand aside on the shelves
below without fully removing them. This will prevent loss or
misplacement of the sha�s during reassembly.
Note: Depending on your choice for the bo�om shelf (Quart or
Gallon) you may need either the Quart or Gallon motor drive
sha�. When replacing either of these two sha�s you will also
need to replace the expanding bolt.
