5
Solving inefficiency problems:
Machine does not wash.
Wrong programme? Consult the programmes table; Has the machine been
loaded correctly? See section 3.2; Are the sprinklers turning freely and/or are the holes blocked? See
sections 3.2 - 4.2; Is the filter fitted correctly? See section 4.1; Are you using the right detergent?
Make sure that it is appropriate for use in the dishwasher and it has not been damaged by keeping it
stored for a long time.
Machine does not dry.
Wrong programme? In short programmes, drying efficiency is reduced; is the
correct amount of rinse aid being used? See section 3.5; If I use an All-in-1 tablet, can I do without
rinse aid? The use of rinse aid considerably improves drying efficiency; are the dishes loaded
correctly? See section 3.2; Are the items to be dried appropriate? For example, Tupperware (plastic)
items are not suitable for drying; when do you remove the items from the dishwasher? It is advisable
to wait 15 or 20 minutes after the programme ends.
The dishwasher does not switch on.
Check the electricity supply, the power connection, whether fuse
has blown or whether you have pressed the on switch correctly .
The programme does not start.
Check whether the door is open or whether you have pressed the start
button correctly (
A type models only
).
The operation of the dishwasher could be occasionally affected by the spillage of dirt. Therefore, to avoid
problems, check the following aspects depending on the fault detected. As a first option, switch the
machine off and on again (Reset)
MODELS WITH
SCREEN
No. OF BEEPS
MODELS
WITHOUT
SCREEN
Door
Water inlet
Drain
Overflow
Temperatura
Temperature
Temperature Detection
Operating Pressure
Water Distribution
Communication
FAULT TYPE:
2
Is the dishwasher door shut?
Is there water in the system?, Is the water supply on?, Is the filter of the input
electrovalve clean?, Is the water inlet hose lying straight and not twisted between
the wall and the dishwasher?, Is the drain at a higher level than the dishwasher
compartment?
1
F1
Is the drain hose free from blockages?, Is the hose straight?, Are filters clean?,
Has the selected programme really ended?
3
4
5
6
7
8
9
10
Are the filters clean and free from dirt, puree, mash, etc.?
Run a programme with dishwasher cleaner… It may be due to the accumulation of
dirt and lime scale deposits in the heating system.
Run a programme with dishwasher cleaner… It may be due to the accumulation of
dirt and lime scale deposits in the heating system.
Switch off the machine and start a new programme
Switch off the machine and start a new programme
Run a programme with dishwasher cleaner. It may be due to deposits that
have formed
If the fault persists, contact your technical support service.
F2
F3
F4
F5
F6
F7
F8
F9
F0
Comments
Aspects to be reviewed: User
If the fault persists, contact your technical support service.
Before calling, check the fault code. Remember that if you switch the machine off you will
cancel the malfunction signals.
When you open the door, the beeper is deactivated. If you want to hear the beeps again, press
the button (on A type models) or the PROG button (on other models)
