25
•
2
USE
2.1 CHOICE OF COOKWARE
Most cookware is compatible with
induction. Only glass, terracotta,
aluminium without a special base,
copper and some non-magnetic
stainless steels do not work with
induction cooking.
We suggest that you choose
cookware with a thick, flat
bottom.
The heat will be distributed
better and cooking will be more uniform.
Never leave an empty pan to heat
unattended.
Avoid putting cookware on the
control panel.
2.2 COOKING ZONE SELECTION
There are several cooking zones
available. Select one which is suitable,
based on the size of the pan. If the base
of the cookware is too small, the power
indicator will start to flash and the
cooking zone will not work, even if the
cookware’s material is recommended for
induction. Take care not to use pans
which are smaller in diameter than the
cooking zone (see table)
When several cooking zones are
used at the same time, the hob manages
Diameter of
bottom of
cookware
10 to 18 cm
11 to 22 cm
12 to 24 cm
15 to 32 cm
18 cm, oval
fish kettles
11 to 22 cm
Max. power of
cooking zone
(Watts)
2400
2800
3700
5000
5000
2800
Diameter of
cooking zone
16 cm
18 cm
23 cm
28 cm
Horizone
1/2 zone
the power distribution, so as not to
exceed its total power.
When you use maximum power (Boost)
on several cooking zones at the same
time, position pans to achieve the best
positioning and avoid arrangements
(
2.2.1/2.2.2/2.2.3)
2.3 SWITCHING ON/OFF
Press the On/Off key
. "0" flashes
in each zone for 8 seconds
(2.3.1)
. If
no pan is detected, select a zoner
(2.3.2)
. If a pan is detected, the «0»
flashes with a dot. You can then set the
power level. The cooking area heats up
automatically.
Switching off a zone on the hob
Press and hold the key for zone
, a
long beep sounds and the display goes
off or an
"H"
appears (residual heat).
Press the On/Off key to switch the hob
off completely.
2.4 SETTING THE POWER
Press the
+
or
–
key
(2.4.1)
to
adjust your power level between 1 and
19 . Pressing the «0» key switches the
hob off.
When switching on, you can go directly
to maximum power (apart from boost)
by pressing the
"–"
key for the zone.e .
Power presets
There are four
keys available that
provide direct access to pre-set power
levels:
= power 2 - Keep warm
= power 10 - Simmer
= power 19 - Sear
BOOST = maximum power
(2.4.2)
a
c
g
f
Summary of Contents for DPI7766XP
Page 84: ...CZ5703167_00 03 17...
