2.13 FONCTION BOIL
With this function you can boil and
simmer water to cook pasta, for
example.
Select a zone and give a short press on
the "Boil" key
(2.13.1)
.
The default quantity of water displayed is
2 litres, but you can change it using the
+
or
-
(2.13.2)
.
Set the quantity of water required (from
0.5 to 6 litres).
Confirm by pressing the «Boil» symbol or
wait a few seconds for automatic confir-
mation.
Cooking starts.
A beep sounds when the water is boiling
and the "Boil" symbol scrolls through the
display
(2.13.3)
.
You can then add the pasta and confirm
by pressing the «Boil» key.
By default, the display shows the power
and a cooking time of 8 minutes.
You can still adjust the power and the
cooking time suggested.
A beep sounds out when cooking is
finished.
NOTE:
It is important that water is at
ambient temperature at the start of
cooking or the final result will be
distorted.
Do not use a cast iron pan with this
function.
You can also use this function to cook
any food that needs to be cooked in
boiling water.
Advice on how to save energy
Cooking with the correctly sized lid
saves energy. If you use a glass lid, you
can control your cooking perfectly.
m
g
•
2
USE
28
Place the pan on the cooking zone, e.g.
28 cm dia.).
Select Boost power and possibly a
cooking time.
Appuyez sur la touche
. Le symbole
«ICS» apparait dans l’afficheur
(2.10.1)
- either the zone chosen is the best one
for the pan and «ICS» disappears
leaving the initial cooking parameters in
the display.
- or the zone chosen is not the best one
for the pan and the display then
indicates which zone should be used
and the settings are transferred to it
automatically (
2.10.2
).
N.B.
: The hob must be cold to use this
function.
2.11 RECALL FUNCTION
This function lets you display the last
«power and timer» settings for all the
burners which were switched off less
than 3 minutes previously.
To use this function, the hob must be
unlocked. Press the On/Off key and then
give a short press on key
(2.11)
.
When the hob is operating, the function
lets you see the power and timer settings
for the burner(s) which have been
switched off for less than 30 seconds.
2.12 SWITCH FUNCTION
This function allows a pan to be moved
from one zone to another while retaining
the original settings (power and time).
Give a short press on the
key; ====
symbols scroll through the display. Select
the zone to which you wish to move the
pan. The settings will be transferred to
the selected zone and you can now move
the pan.
k
l
j
