Dedicated Micros ©2011
7
CamV
u 500
Power Over Ethernet
This product supports POE and when connected to a suitable switch, will not require an external PSU to
drive the device (Bridge and end-span compatible).
Servicing and Repair
Do not attempt to service this unit yourself as opening or removing covers may expose you to dangerous
voltage or other hazards.
Refer all servicing and repair to qualified service personnel.
Equipment
Use only attachments/accessories specified by the manufacturer.
Ventilation
Ensure unit is properly ventilated to protect from overheating.
Camera Care
In order to avoid damaging your camera, note the following points:
CAUTION
•
The camera has threaded mounting points on the top and bottom of the case. Only use a
standard, photographic mounting bolt with a 1/4-20 UNC thread.
•
Before fitting the lens, make sure that its back will not touch the CMOS sensor or associated
components when screwed fully home.
•
Do not touch the image surface of the sensor. If the sensor is accidentally touched, only clean it
using isopropanol.
•
Do not expose the camera sensor to very bright light over a long period of time as this may
cause damage to the sensor. The camera and lens set-up must be correct to avoid possible
damage due to long term exposure to bright light. A lens with an automatic iris is recommended
under these conditions.
