Dedicated Micros ©2011
10
CamV
u 500
Lens Connections
Fixed and Manual iris lenses (for indoor use only) require no wiring connections.
Auto Iris Lens
Connect the auto iris lens to the four-pin connector located on the side of the camera. If the lens does not
have a DD plug fitted then wire the lens to a suitable plug. Pin connections for the iris drive plug are shown
below.
PIN
DIRECT DRIVE AUTO IRIS LENS
1
Control coil positive (+)
2
Control coil negative (-)
3
Drive coil negative (-)
4
Drive coil positive (+)
POE Injector Cable
The POE Injector cable is designed to enable the use of POE (Power over Ethernet) before a POE capable
switch has been installed. It is installed alongside a suitable 48Vdc PSU that can supply 15W is required -
DM/PSU/48V can be purchased separately from Dedicated Micros.
A
Connection to DVR/NVR/Layer 3 Enhanced CCTV Switch
B
Connection to suitable 48Vdc 15W PSU - (DM/PSU/48V)
C
Ethernet cable connection to camera.
Important:
48V is supplied to connection C. There is no voltage at Connection A. Do NOT
connect an ethernet cable from connection C to the DVR/Layer 3 Enhanced CCTV
Switch as this could cause irreparable damage.
POE Injector Power Supply specification
Adaptor socket - 5.5mm diameter with a 2.1mm central circular pin
+48V goes to the centre pin of the power connector - 0V to the outside barrel
