7
rEPlAciNG tHE FlAME EFFEct liGHt
AND lOG-SEt liGHt BUlBS
Step 1:
Remove 12 screws on the back of fireplace and open the rear cover. There are
2 larger screws and 10 smaller screws
Step 2:
You will find 1 x 40W type B-10 bulbs under log-set bed.
Step 3:
Loosen and remove the burnt out bulb and replace with new bulb.
Step 4:
Close the rear cover. Secure the 2 larger screws into the top left corner hole
and bottom right corner holes as shown in the diagram. Secure the 10 smaller
screws into the remaining holes. Make sure the screws are in the correct holes
and have been tightened.
Step 5:
Plug in the unit.
rEPAir SEt
tOUcH-UP rEPAir PAiNt
Paint directly on the mantel unit if necessary.
rEPAirS
If any problems are found with the original parts during mantel assembly such as the
panels cannot be installed with the plastic connector. Try to solve by one of the following
methods.
Tools required:
Electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm),
pencil, hammer, Phillips screwdriver, safety goggles and gloves (if necessary).
wARNING: wEAR GOGGLES BEFORE yOU START DRILLING.
OPTION 1:
Use the spare KD nuts, KD screws and plastic connector.
1. Place the plastic connector on the mantel unit and mark the drill-holes as shown in
Fig. A.
Fig. A
2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10 mm) on the
mantel. Each plastic connector needs 3 holes. See Fig. B.
Fig. B
Fig. C
3. Gently install the KD nuts into the drilled-holes with hammer as shown in Fig. C.
