5
Operating Instructions (Driving)
CAUTION
If you turn the power switch ON and tilt the joystick when the clutch lever set to manual drive, the buzzer will beep “Pi
Pi Pi Pi” to warn you that the clutch has been disengaged.
CAUTION
If the warning lamp (red) lights immediately after the battery is replaced with one that has been charged, there may be a
failure in the system, rendering the wheelchair immobile. In this case, contact your nearest dealer.
Step
4
Adjust the speed.
The speed can be adjusted by moving the speed selector switch up or down.
• When you move the speed selector switch, the battery residual capacity indicator will change
to the speed level indicator. The lamps will flash to indicate the speed level. There is a rabbit
symbol on the high speed side of the speed level indicator and a turtle symbol on the low
speed side.
• When you move the speed selector switch down, the lamp will flash and move to the low
speed side, thus decreasing the speed. When you move the switch up, the lamp will move to
the high speed side, thus increasing the speed.
• If you do not move the switch, the system will set the speed level and the battery residual
capacity indicator will be displayed after a few seconds.
• In the beginning, set the speed level to low speed. Use the high speed after you become
accustomed to the operation.
Step
5
Release the brakes of both wheels.
Step
6
Tilt the joystick to the direction in which you wish to travel.
NOTE
For detailed operating instructions, follow the “Guidelines for Safe Use”.
Step
7
Beware that travel in some areas may involve risk and require careful
operation.
警WARNING
Use in the following areas or environments may involve risk. Always be accompanied by an assistant to ensure safety.
• Railroad crossings
• Sidewalks without fences
• Train platforms
• Meshed covers on ditches and storm drains
• Gravel roads
• Areas where the wheelchair leans sharply to the left or right
• Riding at night
• Getting on and off a lift bus
• Escalators
• Snow, ice, or puddles
• Other areas where wheelchair travel is inappropriate
WARNING
If the motor overheats or the temperature of the battery exceeds the normal range, the system will limit the electrical
current to the motor. In this case, the warning lamp (red) and the power lamp (green) will flash and the buzzer will beep
“Pi Pi ···” continuously.
47
