USER’S GUIDE VIDEO MODEM «OKO»
2002 LLC “Decima”
9
3.6.1 At permanent monitoring:
In this mode immobile photo picture is displayed on the screen of your PC, which changed over on
―Activation‖ event for this mode is fired.
Activation event takes place when exceeding the triggering threshold to motion (image change
percentage in the snapshot), AND/OR through activating an external sensor, connected to the video
modem (see. p. 3.15).
Apply cut-and-try method for picking up the range of triggering using
“Turn-on threshold”
and
“Turn-off
threshold”
sliders located in the frame
“Motion”
. Set the operating mode for the video modem using the
textbox
“Time”
, where you set the time of operation after triggering, or check
“Infinite”
checkbox for
uninterruptible work after triggering. During the set time period after
activation
, the video modem will
permanently transmit the image.
If necessary, in
“Actions on activation”
check ―switch over the external output» checkbox. In this case,
for the time of activation the external actuating device connected to the video modem will be switched
over (see p. 3.15).
3.6.2 Off-line mode:
Allows to program the video modem to operate off-line without permanent connection to PC.
In off-line mode the video modem allows to save in its memory photo pictures and video clips, to
switch over an external actuating device (see p. 3.15), to autodial the preset phone number each time
the activation of the mode takes place.
For more details concerning the memory of the video modem, refer to p.3.8.
Check the checkboxes located in the frame
“Actions on activation”
(Fig. 7) opposite the corresponding
lines. To enjoy autodial choose one of the two phone numbers specified earlier (for setting phone
numbers, see p. 3.4.2).
Press ―Apply‖ button and break the connection by pressing
button. Only after in the status bar
there will be massage ―No connection‖, switch to the mode ―Call waiting‖ by pressing
button (see
Fig. 2) or by choosing ―Receive calls‖ command from ―Connection‖ menu.
ATTENTION! Recording of video clips into the memory of the video modem is carried out only
when there is no connection of the video modem with the computer
! In connection state record
motion of hard disk of your PC.
3.7 Settings for photographing
Click ―Photo‖ tab (Fig. 8).
Set desired sizes of photo pictures for this video channel. In order for the photo picture to be identical
to the viewed fragment of video image (see p. 3.5.2), press
«Same as video»
button. In the frame
―Coding‖, when using color TV camera, check ―Use color‖ checkbox (color photo picture occupies
grater memory space!), set quality by ―Compression‖ slider. If necessary, set ―Delay after activation»
— the time upon expiration after
activation of the mode of motion detection
, the photo picture will be
taken.
ATTENTION!
The sizes of the photo picture must not exceed maximum sizes set through the
“Coder” menu of the main window, menu item “Settings”; otherwise, you will get an error
message.
3.8 Using memory of the video modem:
Click ―Memory‖ tab (Fig. 9).
For this video channel set the mode of memory utilization for accumulation of photo and video images,
also set its maximum size.
ATTENTION!
When fault with supply voltage occurs, photos and video clips stored in memory
of the video modem will be lost!
