7
Stove Performance
Dean Forge Dartmoor Baker 8 Wood Burning
8kW nominal 74.9% Net Efficiency
Dean Forge Dartmoor Baker 8 Solid Fuel (Ancit)
8kW nominal 73.0% Net Efficiency
All stoves are tested to nominal outputs and will often well exceed these kilowatt ratings.
Chimney
The Baker 8 stoves must have a minimum chimney height of 4m measuring from the stove outlet, the
chimney must not be less than 150mm (6”) internal diameter.
These stoves are not suitable to be used in a flue-shared situation.
If the chimney draw is too high a flue stabilizer will have to be installed. When the chimney is warm
the draw should not be lower than 0.10 water gauge.
All appliances have been tested at 12 PA with the doors closed.
It is recommended that this stove is fitted with a liner, the baffle plate can be removed to facilitate
cleaning through the stove.
Hearth, Surround and Register Plate
The stove must stand on non-flammable material at least 12mm thick (1/2”). The hearth must extend at
least 225mm in front of the firebox and 150mm to the sides.
The appliance must be installed on a floor with an adequate low bearing capacity.
If the construction doesn’t meet the existing prerequisite the floor must be reinforced and a load
distributing plate could be fitted.
Optional Rear Heat Shield
When the stove is fitted with a rear heat shield the distance from combustibles to the rear of the stove
can be reduced to 475mm.
If fitted without a rear heat shield the distance to combustibles from the rear of the stove must be a
minimum of 900mm.
Distances from the sides of the stove to combustibles must be a minimum of 600mm.
Flue Connections and Outlets
Please Note:
All profile top stoves use the 6mm black rope seal supplied under the flue spigot to bring
the flue spigot flush with the top of the stove
Summary of Contents for Dartmoor Baker 8
Page 14: ...14...
