EN
4
Use the table below to select the desired diameter based
on the length and the current consumption.
Use the table below to select the desired diameter based
on the length and the power consumption.
S e l e c t i o n o f t h e d i a m e t e r o f t h e p o w e r c a b l e s
S e l e c t i o n o f t h e d i a m e t e r o f t h e s p e a k e r c a b l e s
4. SELECTION OF THE DIAMETER OF POWER CABLES AND SPEAKER CABLES
EN
5 . W I R I N G D I A G R A M S
Connect the speaker cables from the positive and negative terminals of the speakers to the respective outputs of the amplifier
terminal marked with SPEAKER OUTPUT, as shown at the diagram.
To connect the power wire supply
it
is necessary to use special
power
cables
. The fuse is placed in the holder and fixed in the cable cut. One end of the cable is connected to the positive terminal
of the battery, the second one – to the amplifier terminals marked with + 12V. Be sure to use a fuse with the parameters sufficient
for use in the system. The length and diameter of the grounding cable must conform to the length and diameter of the cable +
12V. Connect one end to the negative terminal of the battery and the other end of the grounding cable to the terminals marked
with GND.
Connect the head unit (HU) to low-level inputs of the amplifier using RCA cable.
S
tandard wiring diagram of
mono
amp
lifier to
one subwoofer
Step 1. Connect the speaker cable from (-) terminal of
the amplifier to (-) terminal of the speaker.
Step 2. Connect the speaker cable from (+) terminal of
the amplifier to (+) terminal of the speaker.
Caution!!! The minimum permissible connection load impedance is 1 Ohm.
For models AAB-2900.1D, AAB-4900.1D, AAB-7900.1D, AAB-12900.1D the operating voltage is 9-15 V.
S
tandard wiring diagram of
mono
amp
lifier
to battery.
Step 1. Connect one end of the power cable from (+) terminal of the battery and the second end to the amplifier terminal marked
with + 12V. Do not forget to protect positive power cable with appropriate fuse.
Step 2. Connect one end of the power cable from (-) terminal of the battery and the second end of the grounding cable to the
terminals marked with GND.
Step 3.
Connect one end of the cable to the
Remote
output terminal
at the HU
and the second end to the amplifier terminal marked
with REM
.
