Inserting slides
The viewer is able to handle the international standardized 3D slide frame format 41x101 mm.
With a thickness of 2.5 mm. Currently most used frames are of RBT and made of plastic but
you can also mount the slides on a mask and then put them
between two 1 mm. Thick glasses.
Be careful with slides without glass. Touching the slide
material with your fingers causes damage on the long term,
it acts like acid.
Exchanging slides requires a hexagon screwdriver.
-
Remove the 10 bolts at the edge of the front
panel with the hexagon tool. The front
comes lose, be careful that it does not drop!
-
Now you see the big round slide disk. Every
slide is locked with a small metal strip.
-
Loosen the butterfly nut and turn the strip to the right. Now you can take the slide out
of its slot.
-
Before inserting the slide, check that it is clean. When you accidentally touch the slide
with your fingers, immediately clean the fingerprint with a soft cloth.
-
Replace the slide for a new one. Check that
the slide is not viewed in reverse. Start to
insert the bottom part of the slide on the
steel spring followed by clicking the top in
its place.
-
Lock the slide with the metal strip and the butterfly nut.
-
Wipe remaining dust on the slide away and close the front cover.
