Data Device Corporation
3
BU-65572T Manual
3
HARDWARE INSTALLATION
The
BU-65572T
card is a CompactPCI Peripheral device and may be
inserted into any PICMG 2.0 R3.0 or higher, compatible slot. When
installing the card, the following should be observed:
NEVER
insert or remove the card with the power turned on.
ALWAYS
take proper precautions to guard against static damage. Use a
wrist strap if available, or ensure proper static grounding by touching the
power supply cover
WITH POWER OFF
.
Insert the card into the guide rails within the CompactPCI subrack and
then gently press the card into the Backplane connector. Secure with
proper hardware.
Make sure that adjacent cabling and wiring do not hinder the airflow
around the card.
The
BU-65572T
does not contain any configuration jumpers for selection
of bus connection. Selection of direct or transformer coupling is
performed by way of functions provided in the RTL. In addition to this,
there are no jumpers needed for card installation, as the
BU-65572T
is a
true Plug and Play design. Interrupts and memory selections will be
performed by the operating system as the boot system progresses.
3.1 Card Pinout
This section describes pinouts for the card. The card has two front panel
connectors, a DB-9 that is used for 1553 Bus I/O and a 40 pin Mini-D
connector that is used for TTL, power and IRIG signals. The pinouts for
these connectors are shown in following figures.
NOTE:
All ground returns are connected to the chassis ground.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
