10
USING YOUR ELECTRONIC CONTROL
Control Function Guide
Function
Command
Notes
ON/OFF
Press and hold for 5 seconds.
Unit will immediately turn ON or OFF.
Adjust Temperature
Press or and release.
When the display is flashing, press or to adjust the set
point temperature. Note: temperature displayed is the actual
temperature inside unit.
Toggle Between oF / oC
Hold and for 5 seconds.
The display will change units.
Leave Interior Light On
Press and release to leave interior light on for
12 hours; press again to deactivate.
After 12 hours, factory default is restored; light will turn on when
door is open.
Enable Sabbath Mode
Press and hold for 5 seconds and release.
The oF / oC symbol will flash briefly after 5 seconds. Interior
light and display will go dark and remain so until user resets
mode - unit continues to operate.
Disable Sabbath Mode
Press and release.
Display and interior light return to normal operation.
Temperature displayed reflects actual temperature inside unit. If the
temperature displayed is different than selected, the unit is progressing
towards the selected temperature. Time to reach set point varies based
upon ambient temperature, temperature of product loaded, door
openings, etc.
DCS
recommends allowing the unit to reach set points
before loading.
NOTE
Figure 1
0
Electronic control
Door Alert Notification
When the door is left open for more than 5 minutes:
•
will appear in display
•
Close door to reset
