PS-2 Upgrade Kit Installation Guide
Mounting The PS-2 Board
Cont’d
- Once you have determined the best
locations for mounting the PS-2
Board bracket (A), metal heat sink
bracket (AA), battery pack (I), and
battery charging jack (II), mark the
chassis floor locations using a pencil
or silver marker so you can drill the
holes in the proper locations. If
necessary, determine the location of
the smoke unit switch as well.
Drill the appropriate mounting holes as
determined from positioning the PS-2
board and other components
- Remove the PS-2 board with
plastic mounting bracket (A), metal
heat sink bracket (AA), speaker and
battery from the chassis and place
on an ESD safe area on your
workbench. Removing the motors &
trucks will help protect them from
Any stray metal chips when drilling
mounting holes.
- Drill the holes as marked with the
proper drill size. A 5/32” bit will be
required for the PS-2 plastic
mounting bracket (A) and heat sink
bracket (AA). Use a 1/8” bit for the
battery charging jack mounting
holes.
- De-burr the holes slightly using a
larger drill bit (3/8”) or a deburring
tool. Clean all metal burrs or chips
from the chassis before proceeding.
Carefully remove any metal burrs
resulting from drilling the mounting
holes. Loose metal burrs can damage the
PS-2 circuit board!
13