dCS Delius
User Manual
Manual for Software Issue 2.3x
dCS
Ltd
September 2004
Manual filename: Delius Manual v2.3x.doc
Page 61
email: [email protected]
English version
web-site: www.dcsltd.co.uk
Fitting or Replacing the Batteries in the Remote Control
For safety reasons, the Remote Control is supplied with the 3 batteries packed
separately. Any replacement batteries must be type AAA, MN2400 or equivalent
alkaline leak-proof batteries.
Opening the battery compartment and removing batteries
do this:
Turn the Remote Control unit over and remove the 4 screws shown in
12
using the 1-point Pozidriv screwdriver supplied. Please do not use a Philips
head screwdriver as this will damage the screw heads. Lift off the battery cover.
Figure 12 – Removing the Remote Control battery cover
do this:
To remove discharged batteries, press the + end back against the spring and
pull that end out of the unit. A small key or screwdriver may be used if the
battery is a tight fit. Dispose of the discharged batteries safely.
Fitting new batteries and closing the case
do this:
To fit a new battery, press the - end (the flat end) against one of the spring
contacts in the battery holder then press the battery into its slot. Battery polarity
is indicated on the battery holder and on the diagram below. Always fit a
complete set of 3 new batteries.
AAA
1.
5V
AAA
1.
5V
AA
A
1.
5
V
Figure 13 – Changing the Remote Control unit batteries
IMPORTANT!
Please ensure the batteries are fitted the right way around – failure to do so
may damage the Remote Control and invalidate the warranty. Damage
caused by leaking batteries is not covered by the warranty.
do this:
To re-assemble the case, fit the battery cover, ensuring the side with the
recessed holes is outward. Replace the 4 screws, taking care not to over-
tighten them. The Remote Control is ready for use.