background image

305 N. Springbrook Road

Newberg, OR 97132, USA

92531, Rev. B, 03/17

www.dcionline.com

800-624-2793

LOWER POTENTIOMETER: BASE UP-DOWN (PELTON & CRANE)

Starting Position

Chair Fully 

Lowered

1.  Place a circuit jumper on the pins on Section 8 of the 

Terminal Strip.

2.  Loosen the set screw in the large gear.
3.  With the chair plugged into power, turn the large gear 

counterclockwise until it stops.

4.  Rotate the large gear clockwise two teeth.
5.  Retighten the set screw to secure the adjustment.

SETTING PELTON & CRANE SOFT LIMITS

Soft Limits must be set when the chair’s potentiometers have been replaced or disturbed, thereby losing its calibration. 

Soft Limits control the Base and Seat Back minimum and maximum values.
With the circuit jumper on the pins on Section 8 of the Terminal Strip:
1.  Raise the chair base up to a height of 23 5/8 in.
2.  Press and hold the Learn Button on the chair’s foot control and press the Base UP button on the foot control twice. 

(A single beep from the control board will confirm the set limit.)

3.  Lower the chair base down to a height of 9 5/8 in.
4.  Press and hold the Learn Button on the chair’s foot control and press the Base Down button on the foot control 

twice. (A single beep from the control board will confirm the set limit.)

5.  Recline the Seat Back to its lowest mechanical limit then Incline by 2 in.
6.  Press and hold the Learn Button on the chair’s foot control and press the Recline button on the foot control twice.  

(A single beep from the control board will confirm the set limit.)

7.  Incline the Seat Back to its highest mechanical limit, and then Recline by 2 in.
8.  Press and hold the Learn Button on the chair’s foot control and press the Incline button on the foot control twice.    

(A single beep from the control board will confirm the set limit.)

9.  Remove the circuit jumper from the terminal strip and cycle the chair manually through the limits to verify that the 

settings have been saved.

NOTE:

 After setting Base Up and Down, place the 

jumper on a single pin to prevent loss of the jumper.

Reviews: