DBL Technology EP-636 User Manual
Hardware Address is an address used to enter the MAC address in XX: XX: XX: XX: XX: XX
format.
Broadcast Address is an address used to communicate with the other computers connected to the
PC side of the SIP Phone.
Click “VLAN Enable”, and you will have to input VLAN ID and VLAN QoS.
5.6.2 PC Port Configurations
PC port is configured to make a connection of the network and telephone. There are two modes to
configure a PC port: Bridge Mode and Specify an IP Address Manually.
5.6.2.1 Bridge Mode
In the Bridge Mode, the IP Phone allows a PC connected to the phone to pass through to the
network. No other PC Configuration settings are set; the Advanced Settings, Gateway, Primary
and Secondary DNS field settings are not required and will be ignored.
5.6.2.2 Specify an IP Address Manually
Click “Specify an IP Address Manually”, and enter “IP Address” and “Subnet Mask”.
To Enable DHCP Service, you have to know the starting address, which is used to start the service;
and the ending address, which is used to end this service.
•
42