background image

www.dbtechnologies.com

 [email protected]

 

 

 

SUB 612 

 

Rev 1.1 cod. 420120266Q 

  

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 

Quick start user manual 

Section 1 

 
 
 
 

The warnings in this manual must be observed together with the "USER MANUAL - Section 2"

Le avvertenze nel presente manuale devono essere osservate congiuntamente al “MANUALE D’USO - Sezione2”.  

Die Warnungen in diesem Handbuch müssen in Verbindung mit der "BEDIENUNGSANLEITUNG - Abschnitt 2" beobachtet 
werden”.  

Les avertissements specifiés dans ce manuel doivent être respectés ainsi que les "CARACTERISTIQUES TECHNIQUES -
Section 2" 

Las advertencias del presente manual se deben tener en cuenta conjuntamente con las del “MANUAL DEL USUARIO” - 
Sección 2”. 

 

 

       A.E.B. Industriale Srl Via Brodolini, 8 Località Crespellano 40053 VALSAMOGGIA BOLOGNA (ITALIA)  
        Tel +39 051 969870 Fax +39 051 969725 www.dbtechnologies.com [email protected]

 

 

Summary of Contents for SUB 612

Page 1: ...n in diesem Handbuch müssen in Verbindung mit der BEDIENUNGSANLEITUNG Abschnitt 2 beobachtet werden Les avertissements specifiés dans ce manuel doivent être respectés ainsi que les CARACTERISTIQUES TECHNIQUES Section 2 Las advertencias del presente manual se deben tener en cuenta conjuntamente con las del MANUAL DEL USUARIO Sección 2 A E B Industriale Srl Via Brodolini 8 Località Crespellano 40053...

Page 2: ... 1 Unpacking The box contains N 1 SUB 612 N 1 Mains cable VDE This quick start and warranty documentation 2 Easy installation SUB 612 is equipped with A Houses for stack mounting B Handle 1 on the top C M20 pole mount Those mechanical particulars were thought for an easy use and for different configuration needs In the pictures above is shown an example of configuration for the use of SUB 612 The ...

Page 3: ...el c Choose the Subwoofer Polarity Normal or Reverse 5 to obtain the proper behavior It is possible to add a low frequencies boost 5 with the related Subwoofer Mode switch d Connect the VDE cable to the related connector 7 Then turn ON the power switch 8 The the Signal ON LED 6 turns on signaling the proper power connection and starts blinking at the presence of audio signal greater than 20 dBu Ch...

Page 4: ...ver there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures 1 Reorient or relocate the receiving antenna 2 Increase the separation...

Reviews: