Raider-Classic 150 (Oil-cooled&Internal Gearbox): Service Manual (single/ double-seat) EEC Version;3.0 Feb..2005
26
f) Remove the camshaft holder and dowel pin;
Remove the cam chain wheel from the cam chain, and remove
the camshaft.
3.5.2 Inspection
a) Inspect the camshaft bearings for play. If there is any play, replace the whole set;
b) Inspect the cam surface for damages;
c) Measure the height of the cam.
Inlet Cam
25.96 mm
Exhaust Cam
25.815 mm
3.5.3 Installation
a) Rotate the flywheel to align the "T" mark on the flywheel with
the camshaft mark. At this time, the round hole on the cam
chain wheel should be up, and the left and right should be
parallel with the cylinder head (the lobes of the camshaft are
down).
b) Install the camshaft on the cylinder head;
Mount the cam chain on the cam chain wheel;
Install the dowel pins.
b) Mount the camshaft holder, washer, and nut on the cylinder
head;
Tighten the cylinder head bolt and nut.
c) Turn the cam chain tensioner adjusting bolt anticlockwise and
release the lock;
Apply some oil on the new O-ring;
Mount and tighten the cam chain tensioner cover bolt.
While installing, first apply some oil on the thread part of the camshaft holder bolt.
The camshaft nuts should be tightened diagonally in a 3-step process.
After installing, adjust the valve clearance.
The o-ring must be mounted properly in the groove.
Summary of Contents for Raider-Classic 150
Page 1: ......
