CBT36K Assembly Manual
Page
25
of 89
Twist the 18 AWG stranded wire around the
appropriate resistor lead (use the end with 0.75
inch of insulation removed that has not been
tinned). Apply solder to the resistor leads and the
stranded wire. Repeat these steps for all the mid-
bass parallel resistors.
5.6.3.
Create Four Parallel Resistor
Combinations:
You will end up with two sets of resistors that
match the image above. Form a “J” shape at each
3/4 inch wire end that is tinned (see wire table).
These are for the ND-91 mid-bass drivers.
5.6.4.
Attach Lead Wires to Parallel
Resistor Pair:
Twist the 27” RED 24 AWG wire on the straight
end of these resistors (remember to use the end of
the wire with 3/4” of insulation removed).
Attach Long Lead Wires to Resistors:
Locate the remaining single resistors and connect
wires as follows (
NOTE:
You should have two
complete sets of resistors configured as above and
listed below).
1)
1.0 Ohm - 5” YELLOW 24 AWG
2)
1.5 Ohm - 5” YELLOW 24 AWG
3)
2.5 Ohm - 12” YELLOW 24 AWG
4) 1.5//1.5 Ohm - 27” RED 24 AWG
(Completed in previous step.)
5.7.
A
TTACH
L
EAD
W
IRES TO
S
PEAKON
C
ONNECTOR
:
Locate the Speakon connector and solder wires to
the terminals as follows. Note that the wire end that
connects to the Speakon connector should be the
end that has 0.375” of insulation trimmed off and is
tinned. (
NOTE:
You should prepare two complete
Speakon assemblies as shown above for the left
and right pair of CBT36s.)
1)
12” RED 18 AWG to 1(+)
2)
12” BLACK 18 AWG to 1(-)
3)
15” RED 18 AWG to 2(+)
4)
15” BLACK 18 AWG to 2(-)
