Daytona Users Instructions
200551_01
Page 2 of 4
•
If the E.S. Control operates again, it is advisable to have the appliance checked by a competent electrician.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut out, this appliance must not be supplied through an
external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
Under no circumstances should the heater be used as a free standing appliance. The heater must always
be placed against a vertical surface i.e. back panel against a fireplace and fixed in place using the brackets
provided.
Wall/back panel preparation
Carefully mark out the holes positions, drill and plug wall as shown in figure3.
Fit two No.8x25 long pan head screws leaving approximately 2mm between the wall/panel and the screw head (see figure2)
Fig3 Fig2
Fitting brackets to appliance
Loosen but do not remove the two screws Ref. ‘A’ (figure4) and carefully slide each bracket behind the screw head (figure 5) and re tighten both
screws.
Fig4 Fig5
To finally fix the appliance, locate the keyhole slots in the brackets over the heads of the screws in the wall/panel and carefully
slide down to lock in place.
Fig 6. Minimum distances for installing the appliance
