24
M4FM-HD User Manual
3. Program Loss Relay Outputs –
configures the M4FM-HD for alerts externally via GPIO when
Alarm conditions become active. Each relay can be set to any of the 6 alarms or empty. See figure 10
on page 14 for the DB-15 pinout.
Network Tab
1.
2.
Figure 20.
1. Network Settings –
Enables and disables DHCP. Enabling DHCP allows the DHCP router to
chose an IP address for the M4FM-HD and auto-populate the subnet and gateway. The tuners
MAC is READ-ONLY and cannot be changed. Disabling DHCP allows the user to manually
enter the IP address, Subnet, and Gateway. Select SAVE to store the settings. The settings
are
not
set until saved.
2. Private FTP Settings –
Enables and disables the use of a private FTP site to store firmware
updates. Enabling this feature will direct the M4FM-HD to the host IP provided by the user
when checking for firmware updates. Select SAVE after entering the Host IP, User name,
Password, and Port #. The settings are
not
set until saved.
3. Email Notifications –
Enables and disables emails sent out when alarm conditions are active.
To enable enter SMTP IP, Port #, User name, Password, Sender email address, and receiver
email address. Select SAVE to save the settings and activate. Settings are
not
set until saved.
Select TEST to verify that the settings have been entered properly and emails are
sent/received. *Password is case sensitive alphanumeric. No spaces or symbols may be used.
SSL encrypted logins are currently unavailable –
coming soon in a future firmware release.
3.
