13
The Battery
Charging Your Unit
If you are charging the Boomerbeast directly in the frame there is a chargeport to the left near
the front of the unit that is covered by a plastic flap.
To begin charging, take the charger and
plug it into a 110V wall outlet. Once it
has been plugged in, the light will turn
green to show that the charger is on.
Take the other end and plug it into the
Boomerbeast as seen on the right and
the charger will turn red.
When charging the unit directly to the
battery, use the following procedures
as illustrated however make sure the
Power Setting on the battery is set to 1
(see previous section)
Once it is completely done charging the charger will
turn green again. Once it has turned green unplug the
unit as soon as possible.
If the unit has been charging for over 12 hours and the
light still hasn’t turned green unplug it and plug it back
in to see if it stays green. If it does its done charging.
Do not overcharge the battery, leaving the charger
in the unit can severe damage to the battery, the unit
and surroundings.