13
Using the Power Button to turn the system OFF does not
remove power from the control box. Always disconnect
power at the circuit breaker prior to attempting any
service procedure
.
CAUTION
Ÿ
Salinity:
Located on the Salinity button, this LED is illuminated when the
button has been pressed to display the salt level reading.
Ÿ
No Flow:
This LED is illuminated when the Flow Switch has detected no flow.
This causes the Cell to stop generating chlorine. A flashing LED indicates that
the flow is restored, but there will be a 60 second delay before generation is
reestablished.
Ÿ
Lo Salt:
When this LED is flashing, the salt level is near to its minimum
threshold, which is causing the Cell to operate at low efficiency. When this
LED is illuminated steadily, the salt level is too low and Cell has shut down.
The salt level must be raised before operation is restored. See "Adding Salt"
for more information.
Ÿ
Hi Salt:
When this LED is flashing, the salt level is higher than necessary.
When this LED is illuminated steadily, the salt level is too high and the Cell has
shut down. The pool water must be diluted with fresh water before operation
is restored.
Ÿ
Check Cell:
When this LED is illuminated, Cell efficiency is greatly reduced,
or it is time for regularly scheduled Cell inspection. When illuminated, the
Cell has stopped producing chlorine. The Electrolytic Cell should be
inspected and cleaned (if necessary). Switch off power from the system, and
inspect the Cell. If mineral build-up is present, clean Cell according to the
instructions on page 15. If after inspection, the Check Cell light is still on after
restoring power to the system, then cleaning is necessary even if mineral
build-up wasn't immediately visible to the eye. If illuminated after cleaning,
Cell replacement may be necessary. This light takes priority over any salinity
indicators.
