Step 2: Install handlebars
2:1
2:2
1. Center handlebars in stem and tighten both bolts enough to keep handlebars from rotating down.
(2:1)
2. Be sure cables are not tangled and that they remain on the same side of the bike that they are found
on the frame.
3. Tighten bolts on the side of the stem just enough to keep front wheel from flopping. (2:2) (They
will be firmly tightened later, after installing the front wheel)
Step 3: Install front brake cable to lever
1. Place the cylinder (on the end of the brake cable) into the corresponding ho le in the brake lever.
(3:1)
2. Turn the brake barrel and threaded nut so the slots line up.
3. Pull the brake cable through the slot and push brake cable housing into end of brake lever. (3:2)
4. Turn brake barrel and threaded nut so cable will not fall out. (3:3)
3:1
3:2
3:3
5