daviteq WSSFC-V1A-025, Manual

Page: 3 / 8

For Battery life estimation, please refer to this link.
Figure 2. Product package of WSSFC-V1A-025
With the default configuration, the device can be connected quickly to the Sigfox Network by the following steps.
Device ID Get Devive ID on the device nameplate
Device PAC Get Devive PAC on the device nameplate
Please refer to this link for details
Please refer to this link for instructions on battery installation.
Please refer to section 1.4 Uplink Payload and Data Decoding for details of decoding the receiving packet to get
the measured values.
1.2 What's in the package?
The package includes:
01 x Main device with 2m M12 cable
01 x Magnet key
01 x Wall mounting bracket and screws
01 x Vibration sensor module V1A
1.3 Quick Test
Step 1: Prepare the values of communication settings:
Note: All Sigfox sensors are pre-configured with the correct RC before delivery. The settings of Device ID,
Device PAC, and RC could also be read from the device memory map. Please reference section
3.2 Sensor
configuration for details.
Step 2: Add the device to Sigfox Backend
Step 3: Install the batteries to the device
After installing the battery in 60 seconds, the first data packet will be sent to the Sigfox network. After receiving
the first data packet, the time of another packet depends on the value of the parameter:
CYCLIC_DATA_PERIOD. Additionally, you can use a Magnet Key to force the device to send data instantly.
Step 4: Decode the payload of receiving package
1.4 Uplink Payload and Data Decoding