daviteq WSSFC-V1A-025, Manual

Page: 7 / 8

Interval time to send an uplink message regardless of any conditions
constant_A | Default = calibrated value by factory
This value will affect the measurement accuracy. DO NOT change this value!
Those configuration parameters can be changed by downlink or offline tools. For more other configuration parameters,
please refer to the next section.
Sensor configuration can be configured in 02 methods:
Method 1: Configuring via Downlink message. Please find the instructions in this link , but please take note of
the FW version of the Document.
Method 2: Configuring via offline cable .
Some parameters are read-only, and some are read and writeable.
To read the parameters, use the off-line cable as above instruction.
Via uplink message, users can read only one parameter, which is the CURRENT_CONFIGURATION.
Below tables are the lists of the parameters of the device.
Read-only Parameter Table
Modbus
Register
(Decimal)
Modbus
Register
(Hex)
Function
Code (Read)
No. of
Registers
Description Range Format Property Comment
2 2 3 4 FW_VERSION string Read
6 6 3 2 HW_VERSION string Read
8 8 3 2 DEVICE_ID hex Read Product ID
10 A 3 4 DEVICE_PAC hex Read Product PAC
14 E 3 1 SENSOR_TYPE 1-255 uint16 Read Sensor or
Input Type
Read/Write Parameter Table
Modbus
Register
(Decimal)
Modbus
Register
(Hex)
Function
Code
(Read)
Function
Code
(Write)
No. of
Registers
Description Range Default Format Property Comment
270 10E 3 16 4 CURRENT_CONFIGURATION hex Read/Write Check the
Payload Document
section:
5.
Payload
for
downlink
message
for more
information
274 112 3 16 1 SERVER_CONFIG 0 uint16 Read/Write 0: Send to
Sigfox
Network
1: Send to
Dongle
276 114 3 16 1 RADIO_CONFIG 1-4 4 uint16 Read/Write RC zones
selection
1, 2 , 3, 4
is RC1,
RC2,
RC3s, RC4
3.2 Sensor Configuration
3.2.1 How to configure the Sigfox-Ready V1A Sing-axis Vibration Sensor?
3.2.2 What parameters of the device are configured?