or the buzzer buzzes 3 Beep => release the push button or take the magnet to perform the User factory reset
(User factory reset = reset frequency number, RF transmit power, data rate, Node ID of 40 WS, Modbus operating
parameters, compare time for data status)
If it takes more than 30 seconds, the button will be deactivated
Add Sensor Node ID automatically
Step 1: After supplying power the iConnector via M12 connector, the Node ID must be registered within the first
5 minutes, up to 40 WS.
Step 2: Bring the wireless sensor closer to the iConnector's antenna then take off the wireless sensor battery,
wait for 5s then insert the battery again. If:
Buzzer plays 1 peep sound, LED blink 1 time, that means registering Node ID on iConnector successfully.
Buzzer plays 2 peep sounds, LED blink 2 times, that this Node ID is already registered.
If you do not hear the "Peep" sound, please disconnect the power the iConnector, wait a few minute and
try again.
Node id added in this way will be written to the smallest node_id_n address which is = 0.
Set Rssi_threshold (see RF MODE CONFIG (in the
Modbus Memmap of WS433-CL-FW_V1.9
), default -25): The
case if Co-ordinator is on high position and need to add node sensor. We set the sensor as close as possible and set the
Rssi_threshold to -80, -90 or -100 to increase the sensitivity to allow iConnector can add sensors at a longer
distance. After that, perform 2 steps of adding sensors and then reset Rssi_threshold = -25.
Enb_auto_add_sensors configuration (see RF MODE CONFIG (in the
Modbus Memmap of WS433-CL-FW_V1.9
)):
In case you do not want to turn off the power iConnector, you can set Enb_auto_add_sensors = 1, this way we have
5 minutes to add nodes (add up to 40 nodes) . After 5 minutes Enb_auto_add_sensors will automatically = 0.
Configuration
Protocol: Modbus RTU
Address: 1 - 247
Baud rate: 9600 , 19200
Parity: none, even, odd
Stop bits: 1
Memmap resgisters
You can download Modbus Memmap of WS433-CL-FW_V1.9 with the following link:
5.1 Add Sensor Node
